Alpine A110 - Page 26

USING VOICE RECOGNITION
1
24 - General information
«Favourites»
To retrieve an address saved in
favourites using the voice command.
Press the voice command button
to display the voice command main
menu.
After the sound signal, say
"Favourites" then select your
destination.
The system shows you the address
entered. Confirm your destination to
begin guidance.
"Destination history"
To retrieve a previously entered
address using voice control.
Press the voice command button
to display the voice command main
menu.
After the sound signal, say
"Destination history" then select your
destination.
The system shows you the address
entered. Confirm your destination to
begin guidance.
«Pointsofinterest»
To search for a point of interest using
the voice command.
After the sound signal, say "Find
service station" or "Find hotel".
The navigation system suggests
several POI (points of interest) in
different categories.
Destination in a foreign country
The country must be changed
before you say the address.
Press the voice command button
to display the voice command main
menu.
After the sound signal, say "Change
country", then say the country in which
you wish to carry out your search. After
the second beep, say your destination
address.
Note: you can change country as long
as the country is supported by the
system language.
"Points of interest" in a foreign
country
During your journeys abroad, some of
the vocal commands for categories
may not be recognised.
If you want to search for a point of
interest, say: "Points of interest by
category". The multimedia system
displays the points of interest
categories list. Select one of the
categories.
For further information about using
points of interest, please refer to the
section on "Entering a destination".
Using favourites with voice
recognition
The saved addresses can be called
directly using voice recognition.
Press the voice command button
to display the voice command main
menu.
After the sound signal, say "Display my
favourites".
The system displays the saved
favourite(s).
"Radio" control with voice
recognition
You can activate music, radio or
change waveband using the voice
command included with your
multimedia system.
Press the voice command button
to display the voice command main
menu.
After the sound signal, say:
– "FM station, "AM station",
"DAB station";
or