Alpine A110 - Page 87

UPDATING THE SYSTEM AND MAPS
5
Apps - 85
port. The multimedia system detects
new apps and offers to install them.
Follow the instructions shown on the
multimedia system screen.
This updating procedure must be
carried out while the engine is
running in the case of combustion
vehicles and with the engine on in
the case of hybrid and electric
vehicles.
Note: once the USB flash drive has
been inserted into your vehicle's USB
port, do not carry out any operation on
the multimedia system, its controls or
on any vehicle devices (telephone,
audio, navigation, etc.) to avoid
interrupting the updating process.
When the update procedure is
complete, you can remove the USB
flash drive from your vehicle.
To benefit from updated
maps and speed limits, it is
recommended that you
regularly install updates via the
https://renault-
connect.renault.com website.
The maps and speed limits
are updated
simultaneously. On vehicles
not equipped with navigation, it is
also necessary to carry out
updates in order to update the
speed limit indications.
Updating by creating a virtual image
of your vehicle using a USB drive
From your vehicle, insert a USB drive
which is FAT32 formatted and has a
minimum capacity of 32 GB and a
maximum capacity of 64 GB into your
vehicle's USB port, then wait for 10
seconds (ensure that no other USB
drive is connected).
The multimedia system then saves a
virtual image of your vehicle to the
USB drive, which will enable the
Alliance CONNECT Toolbox software
to identify the updates available for
your navigation system.
After the virtual image has been taken,
remove the USB flash drive from the
USB flash drive of your vehicle, then
go to your computer.
Any new USB flash drive
inserted is analysed and its
image is stored in the
multimedia system. Depending on
the USB flash drive's capacity, the
multimedia screen can be put on
standby. Wait a few seconds.
Only use USB flash drives that
conform to the national
requirements in force.
From your computer, download the
Alliance CONNECT Toolbox software
then insert the USB drive containing
the virtual image of your vehicle.
The Alliance CONNECT Toolbox
software shows the types of update
that are available:
– "Complete update";
– "Update available by country".
Note: only countries where an update
is available for the selected vehicle are
suggested in the list of "Updates
available by country".
Select the updates you want to install
on the multimedia system, then
download the updates to the USB flash
drive.
Once the data is downloaded to the
USB flash drive, you can remove the