Alpine A110 - Page 97

ALPINE TELEMETRICS
6
Vehicle - 95
"Dual clutch gearbox"
This function can be used to play an
animation that demonstrates the
operation of the dual clutch gearbox
12 and provides the following
information:
– clutch temperature 13 ;
– gear engaged (the gear indicated on
the screen and the instrument panel
may differ for approximately two
seconds) 14 ;
– pre-selected gear 15 .
"Stopwatch"
This function shows the following
information:
– stopwatches 16 ;
– total time 20 ;
– time elapsed since the start of the
lap 18 ;
– time for the two previous laps 21 ;
– best lap time 19 ;
– the number of laps 17 .
To start the stopwatch, press the
"Start" button or the stopwatch 22
then, each time the stopwatch 22 is
pressed, the system saves the lap
time.
This time is displayed in the latest lap
time 18 without stopping the main
stopwatch.
Note: when you press the "Start"
button 22 , the "Stop" button replaces
the "Start" function.
Pressing the "Stop" button once stops
the stopwatch (the times are still
displayed).
Pressing button "Reset" clears all the
information and resets the general
stopwatch.
Note: when you press the "Stop"
button 22 , the "Reset" button replaces
the "Stop" function.
"Automatic Stopwatch"
The stopwatch has an automatic
function. Once the starting point is
selected, press " Ready " 22 to start
the lap timer.
The function saves the vehicle position
GPS at the start of the lap. Each time
the vehicle passes this position GPS,
the system saves the lap time.
Note: in automatic mode, the "Stop"
button 22 becomes the " Ready ».