ALPINE TELEMETRICS
6
94 - Vehicle
Indicates the temperature (in degrees
Celsius or Fahrenheit) of the clutch
system.
"Engine speed" (RPM)
Indicates the engine speed (in rpm).
"Performance"
The measurement of performance is
automatic and begins as soon as a
speed above 0 mph (0 km/h) is
detected. It is automatically reset once
the vehicle has stopped for more than
two seconds. The deceleration
measurement begins during a
significant braking.
The performance measured is:
– 0-31 mph (0-50 km/h);
– 0-62 mph (0-100 km/h);
– 0-400 metres;
– 62-0 mph (100-0 km/h);
– 0-1000 metres.
The graph shows the vehicle speed in
relation to the distance travelled.
Note: you can also carry out this test
over shorter distances. The 0-400
metre and 0-1,000 metre parameters
will therefore remain at zero.
"GG diagram"
When you accelerate, slow down or
turn, the vehicle undergoes transverse
and longitudinal acceleration. This
function can be used to see these and
measure them in real time.
The
9
screen enables you to see the
history of values saved by the
multimedia system.
To reset the display to zero, press
"Reset"
8
.
"Engine graphs"
This function can be used to view:
– the engine torque
10
(in Newton
metres);
– the engine power
11
in real time
(horsepower DIN).
To Next Page
Loading...
