9-EN
Accessory List
• Head Unit ..................................................................................1
• Power Cable ..............................................................................1
• Microphone ..............................................................................1
• Mounting Sleeve ......................................................................1
• Carrying Case............................................................................1
• Rubber Cap ...............................................................................1
• Hex Bolt.....................................................................................1
• Bracket key ...............................................................................2
• Screw (M5 × 8) ..........................................................................4
• Owner’s Manual..................................................................1 set
Turning Power On and Off
Press t to turn on the unit.
Note
• The unit can be turned on by pressing any other button except and
e (Release).
Press and hold t for at least 2 seconds to turn off the
unit.
Note
• The first time power is turned on, the volume will start from level 12.
Demonstration Function
This unit has a demonstration feature for display. When Demo mode is
set to ON (initial setting), the unit starts the demonstration if there is no
operation for 30 seconds.
When installing this unit in a car for the first time, the DEMO OFF
screen will be displayed for 30 seconds after turning on the unit.
Press ENTER within 30 seconds to turn off the
Demonstration mode
*
.
Otherwise, the Demo mode remains ON and the unit starts the
demonstration if there is no operation for 30 seconds.
* The operation is the same as setting DEMO MODE to OFF in the
Setup menu. However, if the unit is disconnected from the vehicle’s
battery, DEMO MODE will be switched to ON automatically
when the unit is used next time. If you want to completely close the
Demo mode, set DEMO MODE to QUITE OFF. For details,
please refer to “Demonstration” on page 23.
Source Selection
Press VSOURCE to change the source.
TUNER DISC USB AUDIO
*1
/iPod
*2
BT AUDIO
*3
AUXILIARY
*4
TUNER
*1 Displayed only when no iPod/iPhone is connected.
*2 Displayed only when the iPod/iPhone is connected.
*3 Displayed only when BT IN is set to ON, refer to “Setting the
BLUETOOTH Connection (BT IN)” on page 26.
*4 Refer to “Using the Front AUX Input Terminal” on page 20.
Detaching and Attaching the Front Panel
Notes
• The front panel may become hot in normal usage (especially the
connector terminals on the back of the front panel). This is not a
malfunction.
• To protect the front panel, place it in the supplied carrying case.
• When detaching the front panel, do not apply excessive force as it may
result in malfunction.
Notes
• Before attaching the front panel, make sure that there is no dirt or dust
on the connector terminals and no foreign object between the front
panel and the main unit.
• Attach the front panel carefully, holding the sides of the front panel to
avoid pushing buttons by mistake.
Getting Started
/SOURCE
/ENTER
/
AUDIO/SETUP
e
Rotary encoder
Detaching
Attaching
To Next Page
Loading...
Need help?
General
Weight and Dimensions
