Alpine NVE-N077PS - Resetting after Tyre Replacement; Adjusting the Volume Level for the Navigation System

41
EN
Adjusting the volume level for
the navigation system
Resetting after tyre replace-
ment
Resetting is required when the vehicle's tyres are
replaced. Be sure to perform the following reset-
ting procedure when the vehicle's tyres are
replaced.
Press the MENU button to display
the main menu. Select "Set up" from
the main menu by tilting the joystick
and press ENTER.
The Set up screen appears. Select
"Calib." from the Set up screen by
tilting the joystick and press ENTER.
The Calibration screen appears.
Select "Tyre change" from the
Calibration screen by tilting the
joystick and press ENTER.
1
2
3
You can adjust the volume level of the beep
sound that is produced when the remote control is
operated and the volume level of the voice guide.
Press the MENU button to display
the main menu. Select "n" from the
main menu by tilting the joystick
and press ENTER.
The volume adjustment screen
appears. You can adjust the volume
level in seven steps from 1 to 7.
Select the desired level by tilting the
joystick and press ENTER.
Note:
When you want to turn off the sound of the
navigation system, select "Off" and press
ENTER.
Press the POS. button to return to
the current vehicle position screen.
1
2
3
Volume