Alpine PXA-H510 - Before Adjustment; Parametric Equalizer Adjustment

22
Before Adjustment
English
Adjusting the parametric
equalizer
Press “A.PROC” and select the “P.EQ” mode.
The “P.EQ” indicator lights.
Press “ENT”.
Within 5 seconds, press “BAND” and select the
band to be adjusted.
There are 11 bands. The band switches as
follows each time the button is pressed.
Front speakers : 4 bands
Rear speakers : 4 bands
Center speaker : 2 bands
Subwoofer : 1 band
Note: If the speaker is set to the off mode, the
parametric equalizer for that speaker
cannot be adjusted. Refer to “Setting the
speaker mode” (page 38) or “Turning the
subwoofer on and off” (page 14).
1
A.PROC
DEF.
IIIIIII SURROUND
DOLBY TIMETCRR PRIVATE
PARAMEEQ
2
ENT
3
BAND
125 2.0 -2
1
P.EQ indicator/Indicateur P.EQ /
Indicador P.EQ
Level (-2 in this example)/Niveau (-2 dans cet exemple)/
Nivel (-2 en este ejemplo)
Band and speaker being adjusted
(band 1, front speaker in this example)/
Bande et haut-parleur en cours de réglage (bande 1,
haut-parleur avant dans cet exemple)/
Banda y altavoz ajustados (banda 1,
altavoz frontal en este ejemplo)
Frequency being adjusted (125 Hz in this example)/
Fréquence en cours de réglage (125 Hz dans cet exemple)/
Frecuencia ajustada (125 Hz en este ejemplo)
Bandwidth (2.0 in this example)/Largeur de bande (2,0 dans cet exemple)/
Ancho de banda (2,0 en este ejemplo)