Cautions on
wire
lead connections
When using
third-party
wire cables (power supply
wire), use the supplied screws
to
simplify
the
connection.
Refer
to
the
description
below
for
the
proper procedure.
If
you are in
doubt
about
how
to
make this connection, consult
your
dealer.
1.
Check
the
wire
size.
• For details on
the
wires
size
to
be used, refer
to
the
supplied "Cautions
on
Power Supply Wires
Connection" and "Cautions
on
Power Supply
Wires" (page 19), and then use
the
wire
of
the
specified size.
•
If
the wire gauge used
is
unknown, ask
your
dealer.
2.
Remove the insulation from
the
ends
of
the wire
leads
by
about
7 -
10
mm
(9/32" - 13/32").
7-10
mm
(9/
32
" - 13/
32
")
I I
~
,-----1'---..__
Lead end side
of
~
~
the
product
Twist
the
tip
of
wire leads
NOTES:
•
If
length
of
the
exposed wire
is
too
short, a
poor
connection may occur causing operation failure
or sound interruption.
• On the
other
hand,
if
the
length
is
too
long,
an
electrical short-circuit may occur.
3.
Tighten the hexagon hole screw
with
the
hexagon wrench (included)
to
secure
the
lead.
Before making this connection, use insulated
shrink
tubing
to
cover any exposed
wire
extending beyond
the
terminal.
Power Supply Terminal
Hexagon Wrench (included)
Q Power Supply Terminal
(e
.
g.
S-A32F)
Speaker
Output
Terminals
Hexagon Wrench (included)
I
Hmgoo
hole
m~
~ l
c1,,
,
~
@)
❖-~
7 \ Ospeake,Oo<putTe,mloals
Speaker
Output
Lead(+) Speaker
Output
Lead(
-)
(e.g. S-A32F)
NOTES:
•
Be
sure
to
use
the
Hexagon hole screw attached
to
the
Power Supply Terminal
(0)
or
Speaker
OutputTerminals
(0).
• For safety reasons, connect
the
battery
leads last.
•
To
prevent disconnection
of
the
leads
or
dropping
of
the unit,
do
not
use
the
cabling
to
carry
the
unit.
7-EN
To Next Page
Loading...
Need help?
General
