6 / 44
EN
NL
GENERAL
After relocation, the tower has to once again be
horizontally aligned; this should be done using a spirit
level.
Once again adjust all of the stabilizers, so that they are in
contact with the surface.
II.VII Assembly and/or repair of replacement
parts
Replacement parts supplied by Altrex must be fitted to the
correct Altrex product and in the same way as the part that is
replaced. Assembly (attachment) and/or repair is effectuated
at the own risk and expense of the client. Altrex is not liable
for damage caused by incorrect assembly and/or repair.
Against payment, Altrex can be called in for the repair of your
product, and/or the assembly of the parts in question.
II.VIII Warranty Conditions
This Altrex product has been designed, manufactured and
tested with the greatest care. Should this product be used in
accordance with the instructions and its intended use, a
warranty will apply under the following conditions:
1.
Altrex guarantees the reliability of the product and the
quality of the materials used for the product.
2.
We will rectify any defects that are covered by the
warranty by replacing the defective part, or the product
itself, or by supplying a part for replacement.
3.
Not covered by the warranty are any defects that occur as
a result of the following:
a) Use of the product contrary to its intended use or
contrary to the instructions for use.
b) Normal wear and tear of the product.
c) Assembly or repair by the client or by third parties
(with the exception of fitting the spare parts provided by
Altrex as indicated above under point 2).
d) Any modified governmental regulations concerning
the nature or quality of the material used in the product.
4.
Any defects that are found upon the delivery of the
product should be reported immediately to Altrex.
Should notification of these defects not take place
immediately, the warranty will be null and void. To make
a claim under the warranty, Altrex or your Altrex dealer
has to be provided with the proof of purchase.
5.
Any defects of the product have to be reported to Altrex
or your Altrex dealer as soon as possible, but in any case
within 14 days of the defect being found.
6.
a) Should a claim be made under the warranty
conditions, Altrex has to have the opportunity to be
able to investigate the product in its Quality Centre
The client must make the product available for this
purpose. Should it be established during the
investigation that the product has been used
incorrectly, the costs of the investigation will be
charged to the client.
b) Should the client ask for an investigation to be
carried out by an independent institute, the costs for
this investigation are at the expense of the client
should it be established during the investigation
that the product has been used incorrectly. The costs
of the investigation are also at the expense of the
client if, prior to this investigation, Altrex offered to
repair or to replace the product at no charge to the
client.
II.IX Assembly of the toe boards
Assemble the toe boards according to the diagram.
II.X Securing the frames
Secure the frames with the locking pins.
To Next Page
Loading...