ALTUS NJ1001 - Application Examples; Compact CPU; Single CPU

1. INTRODUCTION
1.1.4. Application Examples
1.1.4.1. Compact CPU
This architecture explores the needs of compact applications. A CPU with integrated power supply (NX3003, NX3004 or
NX3005), 8 positions rack and input and output modules enable the reduction of space and cost in your project.
These architectures presented in Figure 1 and Figure 2 are the most indicated to be used in machinery automation. It is
important to note that the Nexto and Nexto Jet modules cannot be used simultaneously at the same bus, or the architecture is
formed with Nexto or Nexto Jet modules.
Figure 1: Compact CPU with Nexto Modules Figure 2: Compact CPU with Nexto Jet Modules
1.1.4.2. Single CPU
This architecture is based on a single rack, called base rack. This rack is populated with a CPU, a power supply module
(PSU) and the required I/O modules for the application, as shown on Figure 3. The modules order must follow the configuration
rules presented in the configuration tool.
This architecture is intended for use in small applications, like machinery automation.
The same architecture using Nexto Jet modules can be checked in Figure 4 following.
Figure 3: Single CPU with Nexto Modules
Figure 4: Single CPU with Nexto Jet Modules
6