CUID400N | CUID400N | CONTROL UNIT CUID400N 45
ELECTRONIC MODULE
Table 3. List of module elements
Element Designation
1 Inbuilt radio control receiver module
Learn Remote controllers programming button
F
Drive operation mode setup button
(enter / exit setup mode; selection of the settings parameter; saving the selected settings value)
+ Selection button to increase the value of the parameter
− Selection button to decrease the value of the parameter
CL Settings reset button
FU1 … FU3
High-voltage fuses (10A)
ATTENTION! Use fuses lled with quartz sand!
FU4 Low-voltage fuse (0.8A)
HL1, HL2 Display (display indication during the drive operation is presented in table5)
X1 Network connection socket
2 Connection socket for the electric motor of the drive
3 Lamps connection socket
X6 Remote control antenna connection socket
X9 Connection socket for the drive nal positions switches
X10
Connection socket for the control buttons and indicators (LEDs) module, located on the
control unit housing cover
X11
Connection socket for the control devices, safety devices, additional devices (accessories)
power supply
Table 4. List of module LEDs
LED Indication designation Illuminates
Does not
illuminate
OP.L Open nal position switch (input ‘OP.L’)
was
notactivated
was activated
CL.L Closed nal position switch (input ‘CL.L’)
was
notactivated
was activated
PH1 Closing safety device (input ‘PH1’)
was
notactivated
was activated
S Safety device—STOP (input ‘S’)
was
notactivated
was activated
CL Close and stop command (input ‘CL’) is given is not given
OP Command to open, stop, or close (input ‘OP’) is given is not given
SB Movement stop command (block button ‘STOP’) is given is not given
LR Remote control commands (remote control AT-4) are given are not given
Y
The state of LEDs, when the door is in the intermediate position and there are no com-
mands, is shown in bold.
To Next Page
Loading...
Need help?
General
