BOOM ASSEMBLY
[HA016]
Insert the boom. This operation is easier fitting into the main frame at a slight angle [Fig.1].
To facilitate boom insertion, you can also unscrew the two bolts that hold the tail servo support tray.
* Tighten the M8 nut with HA016 special tool supplied.
* After installation, connect the tail push rod.
* To lock the nut and prevent it from coming loose, install:
- H0287 (for FBL unit installed on the main plate) [Fig.2].
- H0564 (for FBL unit installed on H0564 ) [Fig.3].
NOTE:
[H0287]
1
[H0564]
1: Nylon Screw
M8x14mm
1
To Next Page
Loading...
