DUAL PULSE 125
STORED ENERGY RESISTANCE WELDING POWER SUPPLY
iv 990-270
SAFETY NOTES
This instruction manual describes how to operate, maintain and service the Dual Pulse 125 Stored
Energy Resistance Welding Power Supply, and provides instructions relating to its SAFE use.
Procedures described in this manual MUST be performed, as detailed, by QUALIFIED and TRAINED
personnel.
For SAFETY, and to effectively take advantage of the full capabilities of the tester, please read these
instruction manuals before attempting to use the workstation.
Procedures other than those described in this manual or not performed as prescribed in it, may expose
personnel to electrical hazards.
After reading this manual, retain it for future reference when any questions arise regarding the proper
and SAFE operation of the tester.
Please note the following conventions used in this manual:
WARNING: Comments marked this way warn the reader of actions which, if not followed, might
result in immediate death or serious injury.
CAUTION: Comments marked this way warn the reader of actions which, if not followed, might result
in either damage to the equipment, or injury to the individual if subject to long-term exposure to the
indicated hazard.
To Next Page
Loading...