CP-3000 User’s Guide 4-11
Step 4. When the desired value is displayed,
pressthe YES key. The week number will
flash in the display. To edit these settings,
press the NO key. This will return you to
the display described in step 2. To save
these settings, press the YES key. When
saved, the next menu item, DST End
Date will appear in the display with the
first pair of digits (month) flashing in the
display.
Step 5. Press the NO key until the correct week
number of the year (01 thru 52) appears
in the display. Holding down the NO key
for more than three seconds will
increment thenumber in the display by
ten.
Step 6. Press the YES key. The value entered will
flash in the display. To edit these settings,
press the NO key. This will return you to
the display described in step 4. To save
these settings, press the YES key. When
saved, the display will move to the
Time Card Settings menu.
Step 7. Exit the Program Mode by setting the
Mode Switch to NORMAL.
By Month and Day
Step 1. If you have not already done so, enter
theProgram Mode and press the
FUNCTION key until the Day Change Time
menu item appears in the display.
Step 2. Press the YES key three times until the
DST Begin Date menu item appears with
the first pair of digits (month) flashing in the
display.
Step 3. Press the NO key until the correct month
number (01 thru 12) appears in the display,
and then press the YES key. Holding down
the NO key for more than three seconds will
increment the number in the display by ten.
When saved, the second pair of digits (date
of the month) will flash in the display.
To Next Page
