Cleaning, maintenance and repairs
190
D9 BAH0041-4 08.18
12.9.2 Installation and removal of hydraulic hose lines
When installing and removing hydraulic hose lines, always observe
the following instructions:
Only a specialist workshop may carry out work on the hydraulic
system.
Only use original AMAZONE hydraulic hose lines
Ensure cleanliness.
You must always install the hydraulic hose lines so that, in all
states of operation:
There is no tension, apart from the hose's own weight.
There is no possibility of jolting on short lengths.
Outer mechanical influences on the hydraulic hose lines are
avoided.
Use appropriate arrangements and fixing to prevent any
scouring of the hoses on components or on each other. If
necessary, secure hydraulic hose lines using protective co-
vers. Cover sharp-edged components.
The approved bending radii may not be exceeded.
When connecting a hydraulic hose line to moving parts, the hose
length must be appropriate so that the smallest approved bend-
ing radius is not undershot over the whole area of movement
and/or the hydraulic hose line is not over-tensioned.
Fix the hydraulic hose lines to the intended fixing points. There,
avoid hose clips, which impair the natural movement and length
changes of the hoses.
It is forbidden to paint over hydraulic hose lines!
To Next Page
Loading...
