Version 1.0 ©Copyright 2020, Ambient LLC. All Rights Reserved. Page 3
1. Remove the battery door on the back of the transmitter(s) by sliding down the battery door, as
shown in Figure 2 .
Figure 2
2. BEFORE inserting the batteries, locate the dip switches on the inside cover of the lid of the
transmitter.
3. Channel Number: The WS-2000 and WS-5000 supports up to eight transmitters. To set each
channel number (the default is Channel 1), change Dip Switches 1, 2 and 3, as referenced in
Figure 3.
4. Temperature Units of Measure: To change the transmitter display units of measure (°F
vs. °C), change Dip Switch 4, as referenced in Figure 3.
Switch in down position. Switch in up position.
To Next Page
Loading...
Need help?
General
