Ambit PIB v1.5 - Page 33

Section 3 • Programming Instructions
29
3.2.1.2 PCAModeProgrammingSteps
NOTE: If at any point during programming the user needs to move backward in the
display, refer to instructions found at 3.2.1.3.
ACTION
AUDIBLE
INDICATOR
VISUAL INDICATOR
1 Enterprogrammode:
From pause mode, press and hold
both the RUN/PAUSE button and
the BOLUS button until one beep
is heard.
One beep “PRO” is displayed for two
seconds to indicate that the
pump is in program mode.
2 SelectPCA:
Press and release the RUN/PAUSE
button to scroll up or press and
release the BOLUS button to scroll
down through the program modes
until “PCA” appears in the display.
Press and hold the RUN/PAUSE
button until one beep is heard to
accept the setting.
One beep “PCA”ashesinthe
display.
Mode is established.
3 Setbasalowrate:
(A) Press and release the RUN/
PAUSE button to increase the
number or press and release the
BOLUS button to decrease the
number.
Number left of decimal
pointand“ml/hr”ash.
(B) When the desired number
appears in the display, press and
hold the RUN/PAUSE button until
one beep is heard to accept the
setting.
One beep
NOTE:Basalowrateis
displayed in ml/hr.
(C) Repeat the steps 3(A) and 3(B)
to set the digit to the right of the
decimal point.
The number to the right of
the decimal point and “ml/
hr”ash.Basalowrateis
established.
(D) If during programming, you
need to move backwards in the
display to a previous setting, press
and hold the BOLUS button until
one beep is heard.
Each time the BOLUS
button is pressed, the
display moves backward
one screen to enable review
or correction.
NOTE:Thelimitsforbasalowrateare0.0to20.0ml.
ml/hr
ml/hr