Ambit PIB v1.5 - Page 34

Section 3 • Programming Instructions
30
ACTION
AUDIBLE
INDICATOR
VISUAL INDICATOR
4 Setbolusvolume:
(A) Press and the RUN/PAUSE
button to increase the number or
press and release the BOLUS button
to decrease the number.
Letter “b,” numbers left of
decimal point, “ml” and
bolusiconash.
(B) When the desired number
appears in the display, press and
hold the RUN/PAUSE button until
one beep is heard to accept the
setting.
One beep NOTE:Bolusvolumeis
displayed in ml.
(C) Repeat the steps 4(A) and 4(B)
to set the digit to the right of the
decimal point.
Letter “b” is displayed and
the number to the right of
decimal point, “ml,” and
bolusiconash.Bolus
volume is established.
(D) If during programming, you
need to move backwards in the
display to a previous setting, press
and hold the BOLUS button until
one beep is heard.
Each time the BOLUS
button is pressed, the
display moves backward
one screen to enable review
or correction.
NOTE:Thelimitsforbolusvolumeare0.0to50.0ml.
5 Setlockouttime:
(A) Press and release the RUN/
PAUSE button to increase the time
or press and release the BOLUS
button to decrease the time.
“LOt” and symbols are
displayed for two seconds
to indicate that the pump is
inlockoutmode,“hr:min”is
displayed and the bolus,
lock and clock icons, as well
as the numbers in the hr
sectionwillash.
(B) When the desired lockout time
appears in the display, press and
hold the RUN/PAUSE button until
one beep is heard to accept the
setting.
One beep NOTE:Lockouttimeis
displayed in hours and
minutes.
(C) Repeat the steps 5(A) and 5(B) to
set the digits in the minutes section.
“hr:min”isdisplayedand
bolus, lock and clock icons,
as well as numbers in the
minsection,ash.
Lockout time is established.
ml
ml