American Dynamics ControlCenter ADCC0200 - Setting the Program Lock Passcode

36
ADCC0200 and ADCC0300
Setting the Passcode (Program Lock) Function
IMPORTANT - to set the passcode, the keyboard must be in RS232 mode.
1. Enter the Special Config menu.
2. Press the MENU ( ) key.
3. At the "Program Keylock Enter to Enable" prompt, press the ENTER key.
4. The display will show:
5. The default passcode is "1234". This can be accepted by simply pressing the
ENTER key. Alternatively, a new 4-digit passcode can be entered using the
numeric keys. To enter a new passcode, enter the number using the numeric
keys, then press the ENTER key.
1234
Enter Passcode