Ametek 3050-SLR

User Interface | 4-5
Coniguring Multiple Analyzers
Use the Device Communications tab to set the analyzer’s communication parameters to
agree with the PC settings when controlling analyzers in a daisy chain.
Changing Communication Parameters
• Change the ANALYZER parameter(s) irst.
• Click Apply to conirm the change. This may cause the analyzer to go off-
line.
• Change the PC settings or physical wires/cables.
• Reset the analyzer by recycling power if needed.
Baud Rate
Select the baud rate at which data will be transferred.
Address
Identiies the analyzer’s address. Type the network address for the analyzer being connect-
ed.
Figure 4-3a.
Device Communications setup screen
for AMETEK Serial.