and for HI, LO, and OK indications for individual test results. the X-Bar/R
Chart uses these settings to plot the “high” and “low” test results as red
points on the graph; “acceptable” test results are plotted as green points.
You may also set a low warning and high warning number - those test
results are indicated by a gray color on the statistics output.
The
“Warning”
test
results
do
not
affect
statistical
calculations.
When the Acknowledgment Required box is checked the operator will
have
to
acknowledge
every
time
an
out-of-tolerance
result
is
produced.
NOTE:
Entering
or
leaving
the
values
of
zero
will
deactivate
the
Tolerance
function.
All readings will then be assigned OK status.
After
setting
the
tolerance
values,
select
Finish
to
proceed
Detect Elliptical Impressions
Click here to enter an out of roundness setting of ether 0.1 or 0.2 mm per ASTM recommendations.
Test Load
Use the arrow on the right to display all the available
Scales, 10/500 or 10/3000. Select load and indenter size to
be used.
.
To Next Page
Loading...
