Ametek Sorensen XFR 7.5-300 - Rear Panel SW1 Switch; Figure 1-3 Programming and Monitoring SW1 Switch; Table 1-2 Rear Panel SW1 Switch Assignments

Features and Specifications
1-6 TM-F2OP-C1XN-01
Rear Panel SW1 Switch
The SW1 Programming, Monitoring, and Shutdown Select switch is an
8-position piano DIP switch located on the power supply’s rear panel. See
Figure 1-3. The SW1 switch enables you to choose:
• Resistive programming of output voltage or current limit
• Output voltage and current limit programming scales
• Output voltage and current monitor scales
• Remote shutdown circuit logic
• Over temperature shutdown mode
Table 1-2 shows the functions assigned to each SW1 switch.
Figure 1-3 Programming and Monitoring SW1 Switch
(Switch is shown in factory default configuration.)
1 Resistive Programming of Output Voltage
2 Resistive Programming of Output Current
3 Selects Output Voltage Programming Source Range
4 Selects Output Current Limit Programming Source Range
5 Selects Output Voltage Monitor Range
6 Selects Output Current Monitor Range
7 Selects Remote Shutdown Logic
8 Selects Over Temperature Shutdown Reset Mode
Table 1-2 Rear Panel SW1 Switch Assignments
Switch Function Open
a
a. Factory defaults underlined.
Closed
SW1-1 1 mA current source for resistive programming
of output voltage
Voltage source
programming
Resistive programming
(0-5 k, 0-10 k)
SW1-2 1 mA current source for resistive programming
of output current limit
Voltage source
programming
Resistive programming
(0-5 k, 0-10 k)
SW1-3 Output voltage programming source range select 0-5 V (0-5 k) 0-10 V
(0-10 k)
SW1-4 Output current limit programming source range
select
0-5 V (0-5 k) 0-10 V
(0-10 k)
SW1-5 Output voltage monitor range select 0-5 V 0-10 V
SW1-6 Output current monitor range select 0-5 V 0-10 V
SW1-7 Remote shutdown logic select HIGH=OFF HIGH=ON
SW1-8 Over temperature shutdown reset mode select Auto reset
Latch OFF