Need help?Do you have a question about the Ametek Sorensen XPF Series and is the answer not in the manual?
General| Brand | Ametek |
|---|---|
| Model | Sorensen XPF Series |
| Category | Power Supply |
| Language | English |
Details voltage, current, and power ranges, operating modes, and settings.
Describes meter types, resolutions, and accuracies for displaying measurements.
Covers independent mode, voltage tracking, and synchronous on/off controls.
Details RS232, USB, LAN, and GPIB interface capabilities for remote control.
Specifies AC input, power consumption, operating/storage ranges, safety, and EMC.
Provides crucial warnings regarding earthing, live parts, and maintenance.
Covers AC power connection requirements and proper ventilation for cooling.
Describes suitability for bench or rack mounting and available kits.
Illustrates and describes the output and sense terminals on the front panel.
Details rear panel output, sense terminals, and interface ports like RS232 and LAN.
Guides on powering the unit, setting output state, and presetting voltage/current.
Covers selecting operating ranges and defining custom voltage/current limits.
Details connecting loads, using remote sense for accurate regulation.
Explains overvoltage, over-current, and over-temperature protection, and status lamps.
Describes locking settings and enabling voltage tracking between outputs.
Explains how to turn both outputs on or off simultaneously.
Covers requesting exclusive control and setting instrument addresses.
Explains local/remote modes and RS232 interface details.
Details the USB interface, virtual COM port setup, and driver installation.
Covers LAN compliance, connection, configuration, and web server features.
Details GPIB connector, subsets, and error handling.
Details execution error, limit event, and status byte registers.
Lists default instrument settings upon power-on and after remote reset.
Explains command terminators, separators, and general syntax rules for remote control.
Lists commands for setting voltage, current, OVP, OCP, and reading status.
Covers system commands like *CLS, *ESE, *ESR, and status reporting.
Details required equipment and the step-by-step calibration process.
Describes internal adjustments for the Powerflex circuit, with safety warnings.
Instructions for fuse replacement and safe cleaning of the instrument.
Outlines the RMA process, contact information, and required details for returns.
To Next Page