Ametek SPECTRO ARCOS FHX3X - Page 56

Maintenance
— 56 SPECTRO ARCOS FHX3X — 08.02.2022
In order to remove the components, proceed as follows:
1. Switch off the plasma.
2. Loosen the argon
connection (5).
3. Loosen and remove the clamp
(2) from the spray chamber.
4. Remove the spray chamber (4)
and the spherical joint seal.
5. Loosen the plasma torch (1) by
turning the lever (3)
counterclockwise.
6. Remove the plasma torch.
Fig. 25
7. The OPI has a latch (1), which
is released by pushing it
upwards (2).
8. Carefully pull the OPI at the
handle (3) to the front (4).
9. Remove the OPI from the torch
housing.
 The removal of the OPI is now
complete.
Fig. 26
1
3
2
4