Amprobe AT-2001 - Locating Individual Wires in a Bundle

Amprobe Europe GmbH AT-2000
- 19 -
Fig. 17
Short to Ground
2. A) Connect the alligator clip cordset to the T2200.
B) Attach one clip to one wire and the other to the circuit's return path
(for a line to neutral short, use the neutral wire).
C) Turn the T2200 'ON' and switch to 'LOW'.
D) Turn the R2000 'ON' and switch to 'SHORT' mode.
E) Hold the R2000 near the wire, 2-3 feet from the connection.
F) Adjust the sensitivity to get 3-9 LED's.
G) Switch the T2200's mode switch to 'MED' and then 'HIGH' and
leave it at the position that registers the highest reading on the
R2000.
H) Trace the wire.
Locating Individual Wires in a Bundle
A. Energized Lines
1. Attach alligator clip Cordset to the ILSG.
2. Verify that voltage on the line does not exceed LSG's rating.
3. Connect one alligator clip to the wire you wish to identify and the other
to a separate ground.
4. Turn R2000 'ON' and leave thumbwheel in position '5'.
5. Set mode switch to 'SHORT' and sensitivity to x1.
6. At bundle, pull each individual wire away from the other wires and
touch to R2000 tip.
7. The strongest signal indicates the proper wire.