NetLinx UniCode Functions
176
NetLinx Programming Language Reference Guide
NetLinx UniCode Functions (Cont.)
WC_FILE_OPEN This function opens a file for reading or writing.
SLONG FILE_OPEN (CHAR FilePath[ ], LONG IOFlag, LONG
Format)
Parameters:
• FilePath: String containing the path to the file to be opened
• IOFlag:
1 Read: The file is opened with READ ONLY status. The constant
FILE_READ_ONLY is defined as a value of 1 for specifying this flag.
2 R/W New: The file is opened with READ WRITE status. If the file currently
exists, its contents are erased. The constant FILE_RW_NEW is defined as a
value of 2 for specifying this flag.
3 R/W Append: The file is opened with READ WRITE status. The current
contents of the file are preserved and the file pointer is set to point to the end
of the file. The constant FILE_RW_APPEND is defined as a value of 3 for
specifying this flag.
•Format:
1 Unicode The file is opened as a Unicode formatted file. If the file is opened
as Read or R/W Append and the file is a Unicode formatted file, this
parameter will be set to this value by the function. The constant
WC_FORMAT_UNICODE is defined as a value of 1 for specifying this
format.
2 Unicode BE The file is opened as a Unicode BE (big Endian) formatted
file. If the file is opened as Read or R/W Append and the file is a Unicode BE
formatted file, this parameter will be set to this value by the function. The
constant WC_FORMAT_UNICODE_BE is defined as a value of 2 for
specifying this format.
3 UTF-8 The file is opened as a UTF-8 formatted file. If the file is opened as
Read or R/W Append and the file is a UTF-8 formatted file, this parameter
will be set to this value by the function. The constant WC_FORMAT_UTF8 is
defined as a value of 3 for specifying this format.
If the open operation is successful, this function returns a non-zero integer
value representing the handle to the file. This handle must be used in
subsequent read, write, and close operations.
>0: Handle to file (open was successful)
-2: Invalid file path or name
-3: Invalid value supplied for IOFlag
-5: Disk I/O error
-14: Maximum number of files are already open
-15: Invalid file format
If the file is opened successfully, it must be closed after all reading or writing is
completed, by calling WC_FILE_CLOSE. If files are not closed, subsequent
file open operations may fail due to the limited number of file handles avail-
able.
// Open MYFILE.TXT for readingINTEGER nFormatSLONG
hFilehFile = WC_FILE_OPEN('MYFILE.TXT',
FILE_READ_ONLY,nFormat)
// nFormat will be set to detected file type
To Next Page
Loading...
Need help?
General
