NetLinx Modules
204
NetLinx Programming Language Reference Guide
CASE REC:
{
IF ([dvDECK,nOFFSET_FB+STOP_FB]
OR [dvDECK,nOFFSET_FB+REC_FB])
{
CANCEL_WAIT 'VCR1 REW TO STOP'
CANCEL_WAIT 'VCR1 PAUSE TO STOP'
CANCEL_WAIT 'VCR1 SREV TO STOP'
CALL 'ALL OFF'
MIN_TO [dvDECK,nOFFSET_FN+REC]
CALL 'FEEDBACK' (REC)
}
}
}
}
}
(***********************************************************)
(* THE ACTUAL PROGRAM GOES BELOW *)
(***********************************************************)
DEFINE_PROGRAM
[dcTRANPORTS[1]] = [dvDECK,nOFFSET_FB+PLAY_FB]
[dcTRANPORTS[2]] = [dvDECK,nOFFSET_FB+STOP_FB]
[dcTRANPORTS[3]] = [dvDECK,nOFFSET_FB+PAUSE_FB]
[dcTRANPORTS[4]] = ([dvDECK,nOFFSET_FB+FFWD_FB] OR
(dcTRANPORTS[6].CHANNEL=NO_BUTTON AND [dvDECK,nOFFSET_FB+SFWD_FB]))
[dcTRANPORTS[5]] = ([dvDECK,nOFFSET_FB+REW_FB] OR
(dcTRANPORTS[7].CHANNEL=NO_BUTTON AND [dvDECK,nOFFSET_FB+SREV_FB]))
[dcTRANPORTS[6]] = [dvDECK,nOFFSET_FB+SFWD_FB]
[dcTRANPORTS[7]] = [dvDECK,nOFFSET_FB+SREV_FB]
[dcTRANPORTS[8]] = ([dvDECK,nOFFSET_FB+REC_FB] AND
(![dvDECK,nOFFSET_FB+PAUSE_FB]))
(***********************************************************)
(* END OF PROGRAM *)
(* DO NOT PUT ANY CODE BELOW THIS COMMENT *)
(***********************************************************)
Using a module in a program
To use a module in a program, you must declare it using the DEFINE_MODULE keyword. This tells the
NetLinx compiler to add the module to the program, effectively merging the module's event handling
and mainline code with the containing program (or module). In other words, the program will have one
event table and one mainline routine consisting of code from the main program and all modules declared
using the
DEFINE_MODULE statement.
To Next Page
Loading...
Need help?
General
