AMX NETLINX PROGRAMMING LANGUAGE - Page 89

Event Handlers
73
NetLinx Programming Language Reference Guide
TIMELINE_EVENT[TL1] // capture all events for Timeline 1
{
switch(Timeline.Sequence) // which time was it?
{
case 1: { SEND_COMMAND dvPanel,"'TEXT1-1 1'" }
case 2: { SEND_COMMAND dvPanel,"'TEXT1-1 2'" }
case 3: { SEND_COMMAND dvPanel,"'TEXT1-1 3'" }
case 4: { SEND_COMMAND dvPanel,"'TEXT1-1 4'" }
case 5: { SEND_COMMAND dvPanel,"'TEXT1-1 5'" }
}
}
TIMELINE_EVENT[TL2]
{
switch(Timeline.Sequence)
{
case 1: { SEND_COMMAND dvPanel,"'TEXT2-2 1'" }
case 2: { SEND_COMMAND dvPanel,"'TEXT2-2 2'" }
case 3: { SEND_COMMAND dvPanel,"'TEXT2-2 3'" }
case 4: { SEND_COMMAND dvPanel,"'TEXT2-2 4'" }
case 5: { SEND_COMMAND dvPanel,"'TEXT2-2 5'" }
}
}
DEFINE_PROGRAM
PUSH[dvPanel,1]
{
TimeArray[1] = 1000
TimeArray[2] = 2000
TimeArray[3] = 3000
TimeArray[4] = 4000
TimeArray[5] = 5000
TIMELINE_CREATE(TL1, TimeArray, 5, TIMELINE_ABSOLUTE,
TIMELINE_REPEAT)
}
PUSH[dvPanel,2]
{
TimeArray[1] = 1000
TimeArray[2] = 1000
TimeArray[3] = 1000
TimeArray[4] = 1000
TimeArray[5] = 1000
TIMELINE_CREATE(TL2, TimeArray, 5, TIMELINE_RELATIVE, TIMELINE_ONCE)
}
The example above creates two timelines (TL1 and TL2) that trigger events at the same rate (once per
second).