AMYET S6 E-BIKE
19
P07: Speed measurement magnetic steel number: range: 1-100;
P08: Speed limit: Range 0-50km/h, where 50 indicates no speed limit,
1. Non communication state (instrument control): When the speed is greater than the set
speed, the PWM output is turned off; When the speed drops below the set speed, the
PWM output is automatically turned on, and the driving speed is ± 1km/h of the current
speed; (Only for power assisted speed limit, no speed limit for the handlebar)
2. Communication status (controller control): The driving speed is maintained at the set
value, with an error of ± 1km/h; (Speed limit for power assistance and rotating handle)
Note: The value here is based on kilometers. When the unit setting is converted from
kilometers to miles, the speed value on the display interface will automatically be
converted to the correct mile value. However, the speed limit data set in this menu under
the mile interface will not be converted, which is inconsistent with the actual displayed
mile speed limit value;
P09: Zero start and non zero start settings, 0: Zero start; 1: Non zero start;
P10: Drive mode setting 0: Power assisted drive (how much power is output is determined by
the power assisted gear, at this time The transfer handle is invalid.
P11: Assist sensitivity setting range: 1-24;
P12: Power start intensity setting range: 0-5;
P13: Three types of magnetic steel discs for assistance: 5, 8, and 12 magnetic steel discs
P14: Controller current limit setting default 12A range: 1-20A
P15: Function not yet activated
P16: ODO reset setting: Press and hold the up button for 5 seconds to reset ODO
1: Electric drive (driven by a rotating handle, at which point the assist gear is invalid).
2: Assisted drive and electric drive coexist simultaneously (invalid in zero start state of
electric drive).
To Next Page
