Jumper setting for Master without mics mode
Figure 2-1: Default Hardware Setup
NOTE:
Connectors on the back of the board are noted with dotted lines if applicable.
Reference Design Information
A reference design info package is available for download on the Analog Devices Web site. The package provides
information on the schematic design, layout, fabrication, and assembly of the board.
The information can be found at:
http://www.analog.com/EVAL-AD2428WD1BZ
Reference Design Information
EVAL-AD2428WD1BZ A
2
B Evaluation Board Manual
2–3
To Next Page
Loading...
