Analog Devices EVAL-AD9081 - Page 15

EVAL-AD9081/EVAL-AD9082/EVAL-AD9986/EVAL-AD9988 User Guide UG-1829
Rev. 0 | Page 15 of 26
In Table 4, N/A means not applicable.
Table 4. Use Cases for AD9082-FMCA-EBZ Board View (Uses 100 MHz On-Board Crystal Oscillator, all single link)
Description
Clock
(GHz)
JESD204x
Mode
1
Tx
Interpolation
Rx
Decimation
Tx
Data
Rate
(MSPS)
No. of Tx
Channels
Rx
Data
Rate
(MSPS)
No. of Rx
Channels
Link Line
Rate
(Gbps/lane)
JESD204x
Protocol
2
Tx Rx Tx Rx Coarse Fine Coarse Fine
4D2A,
12 GSPS
DAC,
1.5 GSPS
I/Q, 6 GSPS
ADC, Full
Bandwidth
12 6 15C 19C 8 1 1 1 1500 4 6000 2 24.75 C
2D2A,
12 GSPS
DAC,
1.5 GSPS
I/Q, 6 GSPS
ADC, Full
Bandwidth
12 6 10C 19C 8 1 1 1 1500 2 6000 2 24.75 C
6 GSPS DAC,
1.5 GSPS
I/Q, 6 GSPS
ADC, Full
Bandwidth
6 6 15C 19C 4 1 1 1 1500 4 6000 2 24.75 C
12 GSPS
DAC, 4 GSPS
ADC,
250 MSPS
I/Q
12 3 9B 6B 8 6 4 6 250 4 250 2 10 B
Dual Band
Setup,
6 GSPS DAC,
3 GSPS ADC,
375 MSPS
I/Q
6 3 16B 10B 8 2 4 2 375 4 375 2 15 B
6 GSPS DAC,
6 GSPS ADC,
1000 MSPS
I/Q
6 6 28C 22C 6 1 6 1 1000 4 1000 2 24.75 C
AD9207 Full
Bandwidth
N/A 6 N/A 19C N/A N/A 1 1 N/A N/A 6000 2 24.75 C
NCO Test
Mode
12 N/A 9B N/A 8 6 N/A N/A N/A 4 N/A N/A N/A N/A
1
B means JESD204B, and C means JESD204C. Note that Rx mode applies to the ADC data path (or JESD204 Tx/JTx), and Tx mode applies to the DAC data path (or
JESD204 Rx/JRx). For more information about the JESD204B or JESD204C modes, refer to the UG-1578, System Development User Guide for the AD9081 and AD9082
Direct RF Sampling Transceivers.
2
B means JESD204B, and C means JESD204C.