Analog way QuickMatriX QMX150 - Page 35

35
In this case, you can enter manually into each input sengs by using the le menu:
Under the SIGNAL tab, you will nd:
- ACTIVE PLUG: select the plug used by the unit at the moment. Only
this plug can be displayed on your output,
 select the plug you want to set up, all changes will be
applied to this plug, even if this plug is acve or not (do not mismatch
with the acve plug),
 dene the type of your signal, video SD/HD YUV/RGB
or Computer HV/SOG etc.,
 enable/disable the input,
 aect the input to the ref sync input. Use this box only
if your source is genlocked with the referenced source (framelock
feature),
 rename your input according to your source,
 select the audio input that will be linked with the
video input,
 status indicates if an embedded audio
signal is detected or not,
 format and size of the input. For the HDBaseT input, the
status also provides the Signal Quality of the HDBaseT link.
Black: select Black to transform your input in a uniform color,
 use this buon to freeze the specic input,
 choose the EDID for the selected plug.
Under the HDCP secon, you can:
- Enable/disable the HDCP communicaon feature
- Read the HDCP status, If the HDCP status says Acve, this output connecon is
currently ulizing HDCP to protect the signal. if the HDCP status indicates Idle, this
output connecon is currrently not ulizing HDCP.
Next is the IMAGE tab, where you can nd all sengs about the display of your input:
7.2.6 Input management