Analog way QuickMatriX QMX150 - Page 36

36
7.2.6 Input management
Under the COLORIMETRY secon, you have:
 dene the selected input luminosity level,
 dene the selected input contrast level,
dene the selected input color level (0:black and white, full: full color),
 set up the hue phase of your NTSC signal.
Under the SHARPNESS secon, you nd:
 dene the selected input luinosity level.
Under the USER GAIN secon, you nd:
 increase/decrease the Red/Green/Blue level of your input.
Next you have the ASPECT tab. All sengs about the blanking and aspect rao are available there:
Under the BLANKING ADJUSTMENTS:
- H&V POSITION SIZE: you can manually adjust the input blanking with the V&H size or posion.
Under the ASPECT RATIO secon:
 forces a parcular aspect rao for the source. (5:4, 4:3, etc). This seng has no eect when set
to nave,
 choose a specic cropped rao if you use a source with black bands on top/boom or
le/right,
 dene the way the image will be displayed into a layer (full screen, centered, cropped or 1:1),
 choose to apply or not a predened zoom on the image (use with video signal).
Next sengs available on the
ASPECT tab are:
 use the Top, Boom, Le
and Right values to crop your
input.