AND TALKING PREMIUM+ - Measurements Part 1; Standard Measurement Procedure

E-17
Measurements
1. Press the START button. All of the
display segments are displayed. Zero (0)
is displayed blinking briey. The display
changes, as indicated in the gure at
the right, as the measurement begins.
The cuff starts to inate. It is normal for
the cuff to feel very tight. A pressure bar
indicator is displayed, on the left edge of
the display, during the ination.
Note: If you wish to stop ination at any time, press the
START button again
2. When ination is complete, deation starts
automatically and blinks, indicating that
the measurement is in progress. Once
the pulse is detected, the mark blinks with
each pulse beat.
Note: If an appropriate pressure is not obtained, the device
starts to inate again automatically. To avoid re-ination,
see “Measurement with Set Pressure”.
3. The display measurement is complete, the
systolic and diastolic pressure readings
and pulse rate are displayed. The device
announces the measurement results.
The cuff exhausts the remaining air and
deates completely
4. Press the START button to turn the
device off. After one minute of non-
operation, the device will turn off
automatically.
5. The reading is then stored into
memory. See "About Memory" for more
information.
START
Measurement
in progress
Systolic pressure
Diastolic pressure
Pressure Rating Indicator
Pulse rate
Exhausts remaining
air automatically
Press
Pressurizing
Zero display
At heart level
Starts inflation
All of the display
segments displayed