TV Punch-Through Function
About: When enabled, this feature allows assigning all TV related keys to always send codes programmed
under TV mode, no matter what mode the remote currently resides. This feature has been enabled by
default. Keys affected are Power, VOL+, VOL-, Mute, Input and Sleep. Follow steps below to enable or
disable this feature.
1. Press and hold [S] and [ENTER] keys simultaneously for about three seconds until indicator light
lights and remains on, release both keys.
2. Device mode indicator light will light. It doesn’t matter which mode lights.
3. Input code [9] [9] [9] [1].
a. Enabled – (0 blinks): If LED turns off directly after inputting the four digits, this indicates
that “TV punch-through” was successfully enabled;
b. Disabled – (2 blinks): If LED blinks 2 times after inputting the four digits; this indicates that
“TV punch-through” was successfully disabled.
Individually assign key Punch-through Lock
Note: Before proceeding; the following features must be first DISABLED: “TV Punch-through Function,”
“STB punch-through Function,” and “Single Press Combined Power Key.”
About: This allows for individually assigning keys to “punch-through” to the mode of your choosing. After
enabling punch-through, the key will always send code for assigned mode no matter what mode the remote
currently resides.
1. Press and hold [S] and [ENTER] keys simultaneously for about three seconds until indicator light
lights and remains on, release both keys.
2. Input the 2 digits code [9] [8].
3. Press the button you want to lock.
4. Press the device mode button you want assign it to (e.g. [TV] or [STB])
a. If successful, LED will turn off directly after pressing the Mode button. Repeat steps 1 – 4
for each button lock.
Notes: Applicable to all buttons except for: [S], [TV], [STB]. To r e-assign a key to different mode, you first
unlock the key using steps from Individually Assign Punch-through Unlock section below, then repeat steps
1-4 to reassign it to correct mode.
To Next Page
Loading...
