28 CMX 240 Series Installation Guide
Using the CLEAR MEMORY Button
The CLEAR MEMORY button is the red button located near the top
center of the controller. You press the red button only to cold start the
controller.
Connecting the Andover Controls Service Tool
The SERVICE PORT, on the lower left corner of the controller, is to
connect the Andover Controls Service Tool to any CMX 240. The ser-
vice tool will access all Infinet controllers on the same Infinet. For
information on availability of the Andover Controls Service Tool, con-
tact your Andover Controls representative.
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
