MT8852B Programming Manual PN: 13000-00110 Rev. V 11-1
Chapter 11 — Configuring Tests in
Single Payload Mode
11-1 Single Payload Configuration (SPCFG)
This command is used to configure parameters when test scripts are carried out in Single
Payload mode (see Operation Manual for more information on this mode). When running a
script in this mode, the instrument uses the configuration parameters listed below.
Note that for the tests listed below, the instrument does NOT support measurements on the
received packets when in Single Payload mode.
• Receiver sensitivity (BER)
• Receiver Maximum Input Power (BER)
• Power Control
• Any of the six EDR measurements (MT8852B, MT8852B-042 only)
• Any of the six low energy measurements (option 27 and MT8852B-043 only)
The PKTTYPE parameter allows selection of all EDR packet types, as well as the Basic Rate
packets. This is to allow continuous transmission of any packet when using the instrument
as an ‘interferer’ for certain types of tests (e.g. C/I Performance or Blocking Performance
tests). All EDR packets looped back to the instrument is discarded (i.e. no measurements is
made).
Set command format SPCFG<ws><script_num><,><variable><,>[<params>……]
<script_num> 3 to 10
<variable>
TSTCTRL Test control to use in test
PAYLOAD Set the test control payload type
PKTTYPE Packet type to use in performing test
HOPSTATE Set the hopping modes used
TXFREQ Set the Tx frequency value
RXFREQ Set the Rx frequency value
DIRTYTX Use dirty parameter table ON/OFF
DEFAULT Restore the default settings (set only)
<params>
Specify either frequency (FREQ) or channel (CHAN).
Query command format SPCFG?<ws><script number><,><variable>
To Next Page
