System Configuration
5-4 PN: 13000-00110 Rev. V MT8852B Programming Manual
CONFIG (Tester Configuration)
Under this system configuration section the following parameters can be controlled:
FILTER Set | Query Measurement filter bandwidth setting
GPIB Set | Query Tester GPIB address
LKTIMO Set | Query Tester’s link timeout setting
MODINDEX Set | Query Tester modulation index set up
NPMODE Set | Query Measurements done on POLL/NULL sequence
RANGE Set | Query Tester measurement power range hold
RS232 Set | Query Tester RS232 baud rate
RSMODE Set | Query Tester rear panel RS232 mode
FILTER (Filter Setting)
This command is used to change the measurement bandwidth when performing the frequency
receiver tests (Initial Carrier, Carrier Drift and Modulation Index). The default
measurement bandwidth is set to 1.3 MHz, but this can be changed to 2 MHz.
Set command format SYSCFG<ws>CONFIG,FILTER,<type>
where <type> is 2MHZ or 1.3MHZ
Example Set the measurement bandwidth to 2MHZ:
SYSCFG CONFIG,FILTER,2MHZ
Query command format SYSCFG?<ws>CONFIG,FILTER
Example SYSCFG? CONFIG,FILTER
Response SYSCFG CONFIG,FILTER,2MHZ
To Next Page
