System Configuration
MT8852B Programming Manual PN: 13000-00110 Rev. V 5-5
GPIB (Tester GPIB Address)
LKTIMO (Link Timeout Setting)
This command sets the amount of time the unit waits after loosing a (Bluetooth) link before
abandoning the connection. This command is used before a link is made.
Set command format SYSCFG<ws>CONFIG<,>GPIB<,><address>
<address> 1 to 30 (Default 27)
Remarks If the GPIB address is changed, any further GPIB communication
must be performed to the new GPIB address.
Example To set the GPIB address to 5 the command would be:
SYSCFG CONFIG,GPIB,5
Query command format SYSCFG?<ws>CONFIG<,>GPIB
Response The response is returned in the form of the command to set that
state.
Example SYSCFG? CONFIG,GPIB
If the GPIB address is 6 the response would be:
SYSCFG CONFIG,GPIB,6
Set command format SYSCFG<ws>CONFIG<,>LKTIMO<,><timeout>
Timeout 1 to 40 seconds. Default is 10. (Integers only)
Example To set the link supervision timeout to 25 seconds:
SYSCFG CONFIG,LKTIMO,25
Query command format SYSCFG?<ws>CONFIG<,>LKTIMO
Response The response is in the form of the command to set that value
Example If the timeout value is 15 seconds the response would be
SYSCFG CONFIG,LKTIMO,15
To Next Page
