Anritsu MT8852B - EUTSRCE (EUT Address Source)

System Configuration
5-18 PN: 13000-00110 Rev. V MT8852B Programming Manual
EUTSRCE (EUT Address Source)
Set command format SYSCFG<ws>EUTSRCE<,><source>
<source>
MANUAL
RS232
INQUIRY
USB
BLE2WIRE
USBADAPTOR
Remarks This command is used to set the source of the EUT address.
MANUAL The address of the EUT is entered via the front
panel or GPIB.
RS232 The EUT address is acquired via the RS232 HCI
link and the EUT is initialised for tests.
INQUIRY The EUT Bluetooth address is obtained by
performing an inquiry. If the EUT address
source is set to inquiry, a GPIB Run command
will produce an execution error if the number of
responses is set to greater than “1”.
USB The EUT address is acquired via the USB HCI
link and the EUT is initialised for tests.
BLE2WIRE The BLE2WIRE link is used to initialize the
EUT for tests.
USBADAPTOR The EUT address is acquired via the USB-Serial
link and the EUT is initialised for tests
USBBLE2WIRE The EUT address is acquired via the USB-
BLE2-Wire link and the EUT is initialised for
tests.
Example To set the EUT address source to MANUAL the command would
be:
SYSCFG EUTSRCE,MANUAL
Query command format SYSCFG?<ws>EUTSRCE
Response Response is in the form of the command to set that state.
Example If the EUT address source was manual the response would be:
SYSCFG? EUTSRCE
Response SYSCFG EUTSRCE,MANUAL