Chapter 10 — GSM Commands 10-4 :FETCh Subsystem
MS2720T PM PN: 10580-00341 Rev. C 10-7
:FETCh:PVTFrame?
Title: Fetch Power vs. Time (Frame)
Description: Returns the most recent Power vs. Time (Frame) measurement results.
The Power vs. Time (Frame) measurement must be the active
measurement. The current measurement can be queried using
CONFigure?. Use the CONFigure:PVTFrame command to set Power vs.
Time (Frame) as the active measurement.
Data is returned as 9 comma-delimited values: Channel Power in dBm,
Burst Power in dBm, Average Burst Power in dBm, Span in MHz,
Occupied Bandwidth in MHz, Frequency Error in MHz, Frequency
Error (ppm), Modulation Type, and TSC. “--” is returned for each data
that is not valid at that instance.
Related Command: MEASure:PVTFrame?
CONFigure:PVTFrame
READ:PVTFrame?
:FETCh:PVTSlot?
Title: Fetch Power vs. Time (Slot)
Description: Returns the most recent Power vs. Time (Slot) measurement results.
The Power vs. Time (Slot) measurement must be the active
measurement. The current measurement can be queried using
CONFigure?. Use the CONFigure:PVTSlot command to set Power vs.
Time (Slot) as the active measurement.
Data is returned as 9 comma-delimited values: Channel Power in dBm,
Burst Power in dBm, Average Burst Power in dBm, Span in MHz,
Occupied Bandwidth in MHz, Frequency Error in MHz, Frequency
Error (ppm), Modulation Type, and TSC. “--” is returned for each data
that is not valid at that instance.
:FETCh:SPECtrum:MULTi?
Title: Fetch Multi-Channel Spectrum
Description: Returns the most recent Multi-Channel Spectrum measurement
results. The Multi-Channel Spectrum measurement must be the active
measurement. The current measurement can be queried using
CONFigure?. Use the CONFigure:SPECtrum:MULTi command to set
Multi-Channel Spectrum as the active measurement.
Data is returned as 1 value: Span in MHz.
Related Command: MEASure:SPECtrum:MULTi?
:CONFigure:SPECtrum:MULTi
READ:SPECtrum:MULTi?
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com