Anslut 417061 - MAINTENANCE; General Care and Cleaning; Air Filter Maintenance

EN
109
MAINTENANCE
GENERAL CARE AND MAINTENANCE
• Switch o the appliance and unplug the power
cord before cleaning and/or maintenance.
• Do not use strong chemicals, detergents or
solvents.
• Do not pour or rinse water on the appliance –
risk of electric shock.
• A damaged power cord must be replaced by an
authorised service centre, or other qualied
personnel, to ensure safe use.
AIR FILTER
• Clean the air lter at least every other week for
best functionality.
DISMANTLING
• The appliance has two lters. Pull the top lter in
the direction of the arrow and fold down (g.
23). Remove the bottom lter by undoing the
screw and taking out the lter (g. 23).
CLEANING
• Wash the lter carefully with hot water and a
mild detergent. Rinse and allow to dry.
ASSEMBLY
• Fit the lter by following the above instructions in
the reverse order (g. 24).
CASING
• Clean the casing with a soft cloth moistened with
a mild detergent and wipe dry.
IF THE APPLIANCE IS NOT GOING TO BE
USED FOR SOME TIME
• Remove the drain plug on the back of the
appliance and connect a hose. Lead the hose to
a suitable drain (g. 20 and 21).
• Remove the bottom drain plug to empty the
bottom tray (g. 22).
• Allow the appliance to run in FAN mode for 6
hours in a warm room to dry the inside and to
reduce the risk of mildew.
• Switch o the appliance, unplug the power cord,
and hang up the cord and plug in the holders on
the back (g. 25). Remove the batteries from the
remote control.
• Clean and replace the air lter.
Remove the top lter.
Remove the screw and
remove the bottom
lter.
Fig. 23
Remove the top
lter.
Replace the bottom
lter and screw.
Fig. 24
Cord holder
Power
cord
Plug
Plug holder
Fig. 25