P/N 1011436 Rev. H 02/21
11
Quarterly Cleaning
1. Turn the power OFF, unplug the power
cord, and allow the unit to cool before
proceeding.
2. Put on heat-resistant gloves and
remove the Bun Feeder and set the
bun thickness compression knobs to
6 & 6.
3. Open both conveyor covers (rear and
front). Disconnect the clips on the
inside part of the Belt Wraps from the
Conveyor Belt Chain.
4. Remove the belt wraps and inspect
both sides of the belt wraps for
damage to the ap, ribs, or silicone
surface. Replace any damaged belts.
5. Clean both conveyor belt chains
(rear and front) with a non-scratch
scouring pad sprayed with degreaser
solution. Rinse with a separate, clean,
sanitizer-soaked towel.
NOTE: Do not spray the toaster with
water or cleaning product.
This can damage electrical
components.
6. Close both conveyor covers. Plug in
the power cord, turn the unit on, allow
belt to make a 1/2 revolution, then turn
the unit OFF and unplug the unit.
7. Open both conveyor covers again
and clean the newly exposed section
of the conveyor belt chains from
left to right and top to bottom with a
non-scratch scouring pad sprayed
with a Degreaser solution. Rinse the
belt wrap from left to right and top
to bottom with a separate, clean,
sanitizer-soaked towel.
Wipe down the belt wraps with a
clean, sanitizer-soaked towel and
allow to air dry before installing.
8. Install the belt wraps around the
conveyor belt chains under the
support rods, making sure the ap is
pointing down.
NOTE: Make sure the Belt Wraps are
installed under the support
rods.
9. Close the conveyor covers and
reinstall the Bun Feeder.
10. Set the bun thickness compression
knobs back to their normal settings.
It is acceptable to adjust the bun
thickness setting as needed to
achieve the desired quality toast and
bun compression.
11. Plug the toaster in and turn the power
switch to ON.
To Next Page
Loading...
Need help?
General
