Antunes VCTM-2 User Manual

®
P/N 1011436 Rev. H 02/21
8
Viewing Settings
To view the toaster settings press and
hold the Menu button (Figure 5) for
approximately 5 seconds. The unit beeps
and shows the settings in the following
order, displaying the value in column 1
first, then the actual setting.
Display Shows Setting Description
ºA - ° F A Platen current
temperature*
bº - ° F B Auxiliary heater
current temperature*
SPEd Speed of belts
Unit Current temperature
Unit
Er Error Code
Et - d Elapsed Time of
toaster usage
Int ° F Internal toaster
Temperature
PL Power Line Voltage
* The first circles shown in these values
represent the Platen indicator lights. The
temperature unit will be shown as ° F or °
C depending on the Unit setting.
Changing Settings
The only settings that can be changed on
the toaster are:
y A Platen setpoint temperature
y B Platen setpoint temperature
y Speed
y Unit
To change these settings, follow these
steps.
1. With the toaster turned off, press
and hold the Menu button and turn
the toaster on. Continue holding the
Menu button until the unit beeps and
EnA appears on the display. Release
the Menu button.
2. Press the Menu button again. The
toaster shows ºA - ° F (A Platen)
and then shows the current A Platen
setpoint value. Use the ▲ and ▼
buttons to change the value as
needed.
3. Press the Menu button to move to the
B Platen setting. Edit as needed.
4. Press the Menu button to move to
the SPEd (Speed setting). Edit as
needed.
5. Press the Menu button to move to the
Unit setting. Edit as needed.
Hi-Limit Reset Button
A Hi-Limit Control turns off power to the
unit if it overheats. To reset the control,
allow the unit to cool, then locate the
Reset Button at the rear of the unit.
Remove the black protective cap, press
the Reset Button, and reinstall the
protective cap (Figure 4).
NOTE: If the Hi-Limit requires
continuous resetting, contact
Antunes Technical Service.
The settings are saved each time you
press the Menu button and move to the
next value. The toaster exits programming
mode after 30 seconds of inactivity.
Factory Reset
To reset the toaster to the original factory
settings:
1. Turn the toaster off.
2. Press and hold both the ▲ and
▼ buttons and turn the toaster on,
continuing to hold the ▲ and ▼
buttons until the unit beeps and
FR (Factory Reset) appears on the
display.
3. Release the buttons.
Display
Up
Arrow
Button
Down
Arrow
Button
Menu
Button
Figure 5. Control Panel and Display

Antunes VCTM-2 Specifications

General

Brand	Antunes
Model	VCTM-2
Category	Toaster
Language	English