Anviz VP30 User Manual

2.4.3 Language
In [System] setup, press [Y IN] or [OUTZ] key and shift to [Language] option,
System ▼
Dev ID 1000
Time
f Language ENG
Press [OK] key to enter language setting interface,
System ▼
Dev ID 1000
Time
f Language ENG
You can press [Y IN] or [OUTZ] key to shift the language. (The system already has
6 languages: Simplified Chinese, Portuguese, Spanish, French, English and Traditional
Chinese. And then press [OK] to confirm.
Then you can continue to do other function settings. And press [C] key to enter
setting save interface.
Set
Save？
No-ESC Yes-OK
Press [OK] key to save system setting. Press [C] to cancel and exit to upper menu.
2.4.4 Network Setting
Network setting main includes IP address, subnet-mask, MAC address, gateway,
far-end IP and far-end limit settings.
In [System] setup, press [Y IN] or [OUTZ] key and shift to [Net] option,
System
f Net
Precision 1
Volume 5
Press [OK] key to enter net parameter interface,
14

Anviz VP30 Specifications

General

Model	VP30
Device Type	IP Access Controller
Fingerprint Sensor	Optical Sensor
Communication	TCP/IP, RS485
Card Capacity	10, 000
Fingerprint Capacity	3, 000
Logs Capacity	100, 000
User Capacity	3, 000
Transaction Capacity	100, 000
RFID Card	125kHz EM card
Voice Output	Yes
Humidity	20% to 80%
Identification Mode	Fingerprint, Card, Password
Access Control Interface	Exit Button, Door Sensor
Relay Output	1
Power Supply	DC 12V
Dimensions	180 x 130 x 40 mm