Anviz VP30 User Manual

System Info ▼
fUser 1000
Card Enroll 1000
Glog 5000
System Info ▲
fSoftVer 02.20.03
User: Registered user number in device
Card Enroll: Registered card number. Select it and press [OK] key and you can
check the same password enrollment number.
Firmware version: the firmware version of program which write in EROM or
EPROM (Programmable read only memory). So called firmware is firm program saved
in integrated circuit firmly, responsible for controlling and dealing with integrated circuit.
After checking completed, click [C] to exit.
2.6 T&A status setting
In T&A status, press [Y IN] or [OUTZ] key to shift attendance status. System
default statuses are IN, Pass, OUT.
BIO-OFFICE OUT
09 : 00 26
09-02-16 Mon
BIO-OFFICE Pass
09 : 00 26
09-02-16 Mon
2.7 T&A
Card only mode:
Swipe user card, after a beep ‘di-’, system will prompt as following,
Card verity
ID 008101
Verified！
ID+ Password mode:
In T&A status, input staff ID through number keypad, i.e. 8108.
24

Anviz VP30 Specifications

General

Model	VP30
Device Type	IP Access Controller
Fingerprint Sensor	Optical Sensor
Communication	TCP/IP, RS485
Card Capacity	10, 000
Fingerprint Capacity	3, 000
Logs Capacity	100, 000
User Capacity	3, 000
Transaction Capacity	100, 000
RFID Card	125kHz EM card
Voice Output	Yes
Humidity	20% to 80%
Identification Mode	Fingerprint, Card, Password
Access Control Interface	Exit Button, Door Sensor
Relay Output	1
Power Supply	DC 12V
Dimensions	180 x 130 x 40 mm