26
(2) Basic and Advanced options
Suggested parameters of “Basic” and “Advanced” for printing PLA are shown in Fig.
28. Stay the mouse upon each box and there will be explanation for it.
(Figure 28)
(3) Plugins
*It is recommended for new user to leave the plugins as default (no plugin enabled).
Plugins are custom settings which will active at specific point during printing. There are
two pre-loaded plugins with Cura: Pause at height and Tweak At Z. More plugins can be
found via: http://wiki.ultimaker.com/Category:CuraPlugin
As shown in Fig. 29, to enable one of the plugins, such as Pause at height, first click it
and then click the drop-down arrow to enter the setting interface.
To Next Page
Loading...
