31
4. When printing finished, the print head and heated bed will be automatically cooling
down. Only remove the printed object from the heated bed when it completely cooled.
Pull the heated bed to the front, and use scraper to carefully remove the object as shown
in Fig. 35. Never direct scarper to your hands.
(Figure 35)
ANYCUBIC i3 MEGA 3D printer has a printing sticker which has a lift time about few
weeks depends on the usage. Customer may use masking tape as alternative.
Tips:
① Suggested printing temperature for PLA: 190-210°C, ABS: 230-240°C, bed temperature for
PLA: room temperature-60°C, ABS: 80-100°C.
② Please be mindful that the nozzle and heated bed are still hot after operation.
③ After operation, switch off the printer after the print head cools to room temperature because
it still needs fan cooling to minimize the clogging.
To Next Page
Loading...
