35
Tips:
① In order to get smooth surface, please use tweezer to remove the excessive filament before
nozzle continuing print at the last point.
② It is required not to move the Z axis after power off otherwise resume will be invalid.
③ ANYCUBIC i3 MEGA 3D supports resume from outage only when print offline
④ This function is developed based on Cura. We could not guarantee that this function
compatible with other slicing software.
⑤ Due to the differences of filaments, temperature, extrusion, etc…we could not guarantee a
perfect surface at the point of “Resume from outage”, especially when printing small object.
To Next Page
Loading...
