Attach E2 (b) to the camera’s hot
shoe mount.
(A ash sync cable can also be used
to connect the In Port [17] on the E2
(b) to the PC terminal on the camera
instead of hot shoe connection.)
Use a camera release cable
corresponding to the camera in use to
connect the Out Port [18] on the E2 (b)
to the remote control terminal on the
camera.*
Set the E2 (b) to Relay State Receive
Mode (Mode Indicator [7] <RECEIVE>
blinks red) and select a radio channel.
* For proper connection with the camera or flash
light, consult the user manual of the actual camera
or ash light at the same time.
• 33 •
To Next Page
Loading...